產品明細

TW163

1分2埠智慧型功率GNSS訊號分配器（10 dB增益）

    產品簡述
    ♦ 從天頂到地平線的軸比很低
    ♦ Geo++校準
    ♦ 相位中心變化非常小（< 1.0 毫米）
    ♦ 低電流（35 mA）
    ♦ 在 2.7 至 24 VDC 電壓範圍內性能保持不變
    ♦ 符合 IP67、REACH 和 RoHS 標準
    ♦ 機殼內預留空間，用於整合 PPP、RTK 接收器或其他 OEM 系統

    <<產品型錄>>
      詢價

      產品詳細介紹Product Introduction

      TW163 1-to-2 Port Smart Power GNSS Signal Splitter  (10 dB gain)


      The Tallysman TW163 is a professional-grade full GNSS band signal splitter that connects one antenna to two receivers, and supports GPS/QZSS-L1/L2/L5, QZSS-L6, GLONASS-G1/G2/G3, BeiDou-B1/B2/B2a/B3, E1/E5a/E5b/E6, NavIC-L5, and L-Band correction services. GalileoGNSS has become a critical component in safety, security, timing, and infrastructure applications, all of which require very high availability. As a result, resilient fault-tolerant components are essential to avoid service interruptions. The design of first-generation GNSS signal splitters suffered from a single point of failure: only one attached receiver powered the splitter and the antenna. If this receiver failed or was unplugged, all attached receivers also failed. Calian's current-generation TW163 Smart Power GNSS signal splitter provides two additional key features: First, it accepts power from all attached GNSS receivers and selects power from a receiver using the following protocol. Port #1 is given priority if its voltage is within the specified range (3.0 V- 12.5 VDC). However, if port #1’s receiver is disconnected or if its receiver power goes below the under-voltage or above the over-voltage specification, the TW163 will switch to the next port in numerical order, as long as its power and voltage are within the expected range. The switching and port selection is, therefore, deterministic. Second, if the antenna fails and does not draw current, the TW163 will provide all connectors with a current draw lower than 1 mA, indicating an antenna fault. The TW163 offers the best in-class performance in terms of noise figure, isolation, and linearity. In addition, it is packaged in a robust, compact, lightweight, and water-proof (IP67) corrosion-protected aluminum housing. The TW163 is available with either TNC or type-N connectors and offers 10 dB gain over the splitting-loss. It is recommended that unused ports should be terminated with a 50 Ohm load.
       
      Applications:
      • GNSS signal distribution
      • GNSS receiver testing
      • High-availability applications
      • Network and infrastructure timing


      Electrical Specifications:

      ParameterConditions / DescriptionMinimumTypicalMaximumUnits
      Frequency RangeBandwidth supported1100-1700MHz
      GainMeasured within range: -40 °C to 85 °C91011dB
      Impedance--50-Ω
      Noise FigureAll Receiver Ports-1.72dB
      Output Isolation-27--dB
      Input/Output SWR--1.3:1 | 1.1:11.5:1 | 1.2:1ratio
      Gain Compression Point (P1dB)Gain of 0 dB-20-17-14dBm
      3rd Order Intercept (IIP3)Gain of 0 dB-10-7-4dBm
      RF Input (Damage Threshold)Maximum RF Input without damage--5dBm
      Amplitude BalanceBetween Ports-0.10.5dB
      Phase BalanceBetween Ports-25degrees (°)
      DC Input RangeDC input on any receiver port3.3-12.5VDC
      Receiver Over-Voltage-12.714.916.9VDC
      Receiver Under-Voltage-2.32.52.8VDC
      Splitter CurrentCurrent consumed by splitter-1525mA
      Antenna Through CurrentMaximum current provided to the antenna--230mA
      Group Delay VariationAntenna to Ports11.42ns
      Adjacent Ports00.30.5ns
      Opposite Ports00.51ns
      TOP